1) remove the case of the steering mechanism from a steering column:

— partially remove a floor covering and an adhesive tape from a transitional plate;

Fig. 7.22. A bolt of a shaft of the leading gear wheel of the steering mechanism (it is shown by an arrow)

— turn a steering wheel and turn out a bolt from a shaft of the leading gear wheel (fig. 7.22);

— fix a steering wheel at the provision of wheels of the car for the rectilinear movement;

— mark the provision of a shaft of the leading gear wheel and casing of a steering wheel;

— put the car on support so that both wheels did not concern a floor;

— remove the heat-insulating screen about half shafts and a forward guard of the engine;

— turn off nuts of fastening of the engine in front and behind;

— turn out four bolts (two long and two short);

— turn out two bolts of fastening of the engine and remove the central longitudinal beam;

— remove bars from the transmission;

— remove a reception pipe of the muffler;

— disconnect stabilizer racks from the lower levers of a forward suspension bracket;

— supporting a cross beam, turn out six bolts;

— lower a cross beam to provide access to fastening of the stabilizer of cross stability;

2) remove the stabilizer of cross stability from a cross beam:

— turn out two bolts;

— lift the stabilizer of cross stability and remove arms;

— remove rubber support;

3) install the stabilizer of cross stability on a cross beam:

— paste two new strips of an adhesive tape to the stabilizer of cross stability;

— establish two rubber support, the stabilizer of cross stability on a cross beam and two arms, having tightened fastening bolts the moment of 25 N · m;

Fig. 7.23. Removal of the stabilizer of cross stability

4) fix a cross beam:

— lift a cross beam and pass via the case of the steering mechanism;

— establish a shaft of a steering wheel on a shaft of the leading gear wheel;

— check combination of the tags made before dismantling;

— attach a cross beam to a body: the moment of an inhaling of long bolts in a forward part — 108 N · m, short bolts in a back part — 88 N · m;

5) fix stabilizer racks on the suspension bracket lever for what use new nuts on the spherical hinge, the moment of an inhaling of 45 N · m;

6) establish a reception pipe of the muffler, fix conducting of the oxygen probe;

7) connect a bar of inclusion of transfers to the transmission;

8) establish the central longitudinal beam, an engine mudguard, the heat-insulating screen, half shafts;

9) to a napressuyta a steering column is farther on a shaft of the leading gear wheel, wrap a bolt the moment of 17 N · m.