The sequence of actions at removal of the pump of the hydraulic booster of steering:

1) disconnect a negative wire of the rechargeable battery;

2) uncover the engine (4 bolts);

NOTE For removal of the generator to shift the pump of the hydraulic booster of steering aside up.

Fig. 10.10. Weakening of the automatic tension device

3) weaken the automatic tension device (fig. 10.10), having turned a pulley to the right, and take off a drive belt;

4) release the automatic tension device in normal situation;

5) disconnect the socket on a back part of the pump of the hydraulic booster of steering;

Fig. 10.11. Arrangement of bolts 1 and 2

6) turn off two bolts 1 (fig. 10.11) fastenings of the pump of the hydraulic booster of steering to the engine block;

7) turn off bolts 2 of a support of the generator and bolts from the pump basis;

NOTE Accurately write down the provision of each bolt.

8) remove the pump of the hydraulic booster of steering up and move away him aside.

PREVENTION Do not disconnect a wire.

The sequence of actions at removal of the generator:

1) disconnect a positive wire of an alarm lamp and I will corrode from the generator;

Fig. 10.12. Arrangement of bolts 1, 2 and 3

2) turn off two fixing bolts 3 (fig. 10.12) from the generator;

3) remove the generator up.

The sequence of actions at installation of the generator and pump of the hydraulic booster of steering:

1) install the generator on the place, wrap bolts a hand and connect conducting;

2) install the pump of the hydraulic booster of steering on the place, having wrapped bolts a hand, and then put bolts 1 and 2;

3) tighten all bolts of the pump of the hydraulic booster of steering and the generator. Inhaling moment: 25 — 30 N · m;

4) install the socket on the basis of the pump.

The sequence of actions at installation of a driving belt:

Fig. 10.13. Fixing of a pulley by means of a face key on 4 mm

1) squeeze the tension device, having turned a pulley to the right, and record it in extreme external situation with the help of the screw-driver and a face key on 4 mm (fig. 10.13);

Fig. 10.14. Installation of a driving belt

2) establish a driving belt on the place and remove a face key on 4 mm which was used as a clamp (fig. 10.14);

3) check the belt course;

4) connect a negative wire of the rechargeable battery;

5) establish an engine cover on the place.