The rubber plugs of draft of control of a convergence which are not replaced. In case of their wear it is necessary to replace draft of control of a convergence assembled for what execute the following operations:

Fig. 8.8. Bolts of fastening of thirst of control of a convergence for a body (1) and longitudinal lever (2)

— mark the provision of an adjusting bolt of 1 (fig. 8.8);

— turn out two bolts 2 longitudinal levers and an adjusting bolt from a body;

— remove draft of control of a convergence;

— mount draft of control of a convergence on the longitudinal lever and tighten bolts the 2nd moment of 35 N · m;

— substitute a support under draft of control of a convergence, wrap a bolt 1 from a body;

— turn an adjusting bolt in former situation;

— remove a support and several times rock the car up-down;

— tighten a nut of an adjusting bolt the moment of 80 N · m;

— check and if necessary adjust the angles of installation of wheels.